Volg ons op Facebook Abonneer op onze RSS

Wii problemen

[Begin] |1(1) [Eind]
Door Marjolein1310 (5 reacties) op 02-03-2011 21:46
Hai!

Sinds een paar uur de trotse bezitster van een wii. Helaas doen de controllers het niet (meer). Ik heb netjes gesynchroniseerd zoals het hoort en hij heeft het even gedaan. Totdat het scherm van de Mii kwam en plots hield de controller ermee op.

Ik heb verschillende dingen geprobeerd: synchroniseren opnieuw, resetten, stroom eraf, batterijen vervangen....ik weet het niet meer. Ik ben echt in staat om dit apparaat op MP te zetten maar dat is ook wel weer zonde. Kunnen jullie mij misschien helpen, voordat ik de helpdesk ga lastigvallen?

Alvast bedankt!
Soepkoe
Door Soepkoe (1704 reacties) op 02-03-2011 21:50
Wat is je exacte probleem? Als je de wii-remote aanzet knipperen de blauwe lampjes dan de hele tijd en gaat de wii niet aan?, is dit zo voor alle wii-remote's?

Gamertag (xbox360, Nintendo-id): soepkoe
Door Marjolein1310 (5 reacties) op 03-03-2011 10:02
Quote:
Wat is je exacte probleem? Als je de wii-remote aanzet knipperen de blauwe lampjes dan de hele tijd en gaat de wii niet aan?, is dit zo voor alle wii-remote's?

Gepost door: Soepkoe op 02-03-2011 21:50

Bedankt voor je snelle reactie!

Het exacte probleem is als volgt:
- alle 4 de lampjes knipperen en gaan daarna uit.
- als ik op een knopje druk van de controller, gaan die 4 lampjes weer knipperen.
- de Wii reageert niet op de controller
- ik heb 1 originele controller bij het pack gekregen en een originele gekocht. In het boekje staat dat de controller die in het pack zat, geïnstalleerd moet worden, evenals de andere controller. Op internet staat dat deze al geïnstalleerd is. Ik heb gisteren 2 controllers gesynchroniseerd.
- de controller bij het pack, de 1e controller dus, deed het gisteren wel maar hield er bij het Miischerm ermee op.
- de bijgekochte controller heeft niet gewerkt op de wii/tv

Ik heb echt alles geprobeerd wat ik op internet kon vinden. Wat zou het kunnen zijn???
Door Kashika (410 reacties) op 03-03-2011 10:08
Ik vrees dat er iets met je Wii zelf is als de controllers het eerst wel deden en nu niet meer.
Het apparaat zelf ontvangt signalen van de Wiimote, dus even Nintendo bellen.

Daarna waarschijnlijk terug naar de winkel met je garantiebewijs.
Ter3
Door Ter3 (152 reacties) op 03-03-2011 11:37
Klinkt als een sync probleem van je wiimotes met je wii, aangezien de wiimotes wel aan gaan, maar geen verbinding kunnen maken.

vam de nintendo site:

Problem: Wii Remote not being recognized by the Wii Console (lights on the Wii Remote flash when you press a button, but then go out)
Getting the Wii console to recognize (or "sync" with) a Wii Remote, especially one that did not come in the box with your Wii console, may require doing a few additional steps before it can be synced. Additionally, a Wii Remote that was working, but is no longer being recognized (or has "lost its sync") may need to be re-synced. Please use the troubleshooting steps listed below, which our experience has shown can solve many Wii Remote issues.

Try these steps!

1. Turn the Wii console power OFF by pressing the POWER Button on the front of the console. Unplug the power cord from the wall outlet for a few seconds. After a few seconds have elapsed, plug the cord back into the wall outlet.

2. Turn the power of the Wii console ON. When you see the Health and Safety screen, open the small flap on the front of the Wii console to find a red button labeled "SYNC." Press and hold the SYNC Button down for 15 seconds. This will clear all the syncs on the Wii, allowing you to get a clean start to begin the process described below.

3. After holding the SYNC Button on the Wii console down for at least 15 seconds, you can now "re-sync" your Wii Remotes:

1. With the first Wii Remote you wish to sync, remove the battery cover on the back of the Wii Remote to find a small red button just below the batteries.

2. Press and release the small red button just below the batteries on the Wii Remote; the blue lights on the front of the Wii Remote will blink.

3. Quickly press and release the red SYNC button on the inside of the white flap on the front of the Wii console (picture).

4. When the Player LED blinking stops and stays lit, the syncing is complete. The LED that is illuminated indicates the player number (1 through 4).

5. This sync procedure (steps "a" through "d" above) must be followed for each additional Wii Remote added to the system.
MitchDylan
Door MitchDylan (297 reacties) op 03-03-2011 12:39
probeer eens knopje 1 en 2 beiden ingedrukt te houden. Had vroeger ook eens zo'n probleem en toen bleek dat ik 1 en 2 beiden moest indrukken toen de wii remote aan het knipperen was terwijl de wii aanstond. Misschien dat dat helpt, het is het proberen waard
Door Marjolein1310 (5 reacties) op 08-03-2011 21:02
Allemaal bedankt voor de reacties!

Ik heb al jullie tips opgevolgd maar de Wii deed het nog steeds niet. Ik ben teruggegaan naar de winkel en zij hebben hem getest zonder resultaat. En ik kreeg een nieuwe mee. Meteen geprobeerd en deze doet het wel!
[Begin] |1(1) [Eind]